INSTALLATION
  • Install two-sided tape (4 to 5cm wide) or apply a 10cm wide strip of release-adhesive around the perimeter of the room. If you use glue, let the adhesive dry for 20 minutes or until it can be touched without transfer.
  • For a full-spread installation with release or permanent adhesive, follow instructions on the pails. To begin, start by laying your floor along the longest wall. Lay a complete row of planks and cut the last one to fit against the opposite wall. The cut edge should always face the wall. When you reach the last row, cut the last plank to fit. The plank should not be forced into place. For best visual effect, always stagger the planks from row-to-row.

Leave a Reply

Your email address will not be published. Required fields are marked *


four − 1 =